Yummy Grape Jelly |
To get started you need 100% grape juice(or any other 100% juice that you like), pectin and sugar.
There are several brands of pectin on the market. Some of them are specifically designed for low or no sugar jams or jellies. I prefer the low sugar variety, when I can find it, as I think it sets and tastes better--but it is a matter of personal preference. Make sure that you follow the recommendations of the pectin that you purchase. Do not try to use regular pectin to make low sugar jam or vice-versa, the jam will not set properly.
The first step is to prepare your jars. Wash your jars thoroughly and then place them in a large pan of water and bring to a boil. Turn off the heat and let set. Or you can run your jars through your dishwasher and use the sanitize cycle, if you have one. You also need to prepare your lids by placing in a pot of hot water.
Lids in pan |
jar rings |
Once your jars are ready, then carefully measure your ingredients. Be sure to check the directions that come with your pectin for juice to sugar ratio. Also, fill your canner half full of hot water and place on stove. Be sure to place a canning rack or towel in the bottom of your canner.
Add your pre-measured juice to a large pot and place on the stove. Stir in your pectin and heat over medium heat until pot comes to a full rolling boil (a boil that doesn't stop when stirred).
Juice in pot |
Remove jelly from heat (be careful the syrup is REALLY hot!), and begin ladling it into the prepared jars using a canning funnel.
Fill jars, leaving a 1/2 inch of space at the top. Carefully wipe the rims of the jars with a paper towel making sure there is no jelly or other debris on the lip, Using a lid lifter, place warm lid on top of jar and use screw band to hold in place, tightening just until tight.
Wiping jar lip |
canner ready for jars |
After your jars are cool, you can remove the rings (if desired). Be sure to label your jelly!
Store your jelly in a cool, dark place (preferably), but at least out of direct sunlight.
No comments:
Post a Comment